B - Cleaning The Recovery Water Tank (Fig. J); C - Squeegee Cleaning (Fig. K); Operations To Be Performed Every 3 Months; A - Check The Wear Status Of The Steering Chain (Fig. L) - Ghibli & Wirbel RACER R 85 FD 65 Utilisation Et Entretien

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
- Once finished cleaning, lift the tube (17),
close it with its appropriate cap (57) and
position it within its appropriate lodgings.
13.2.b - Cleaning the recovery water
tank (Fig. J)
WARNING:
At the end of the washing operations,
it is compulsory to clean the recov-
ery water tank to prevent deposits or
scaling and the proliferation of bacte-
ria, odours or mould.
- Lift the cover (12).
- Remove the dirt collection basket (58)
and open its cover, then clean with run-
ning water, also removing eventual pieces
of paper, wood, etc... that are clogging it.
- Remove and clean the suction filter (59)
with running water.
- Leaving the discharge pipe (15 Fig. H)
low and the cover removed, fill with water
through the upper opening (60), then flush
inside the tank until clean water flows out
of the discharge pipe.
- Reassemble all parts working in the re-
verse order.

13.2.c - Squeegee cleaning (Fig. K)

In order to clean the squeegee correctly (20),
it is necessary to remove it as follows:
- Disconnect the hose (16 Fig. C) from the
squeegee (20).
- Loosen the knobs (36 Fig. C) and remove
the squeegee (20).
- Wash the squeegee and in particular the
rubber blades (60) and the inside of the
aspiration connector (56).
NOTE:
SIf, during washing, it is clear that the rubber
blades (60) and (61) are damaged or worn,
it is necessary to replace them or turn them
over.
- Replace all the components in reverse
order.
13.3 - OPERATIONS TO BE
PERFORMED EVERY 3 MONTHS
13.3.a - Check the wear status of the
steering chain (Fig. L)
- Check the wear and corrosion status of
the chain (63) found beneath the machine
near the front wheel.
- If the chain appears corroded, it must be
replaced.
- Contact the technical assistance service.
13.4 - OPERATIONS TO
PERFORM WHEN NECESSARY
13.4.a - Brushes replacement (Fig.
M)
The brushes must be replaced whenever
they appear worn or whenever their bristles
are shorter than 2 cm. They must also be
replaced based on the type of flooring to be
cleaned; in order to replace them, perform
the following operations:
- Insert a hand beneath the brush support
unit (19). In order to detach the brush, turn
it quickly and forcefully in the opposite di-
rection from that in which it rotates during
normal function.
- Place the new brushes beneath the brush
support unit (19).
- Get into the driver's seat and turn the key
(29 Fig. F) to its "ON" position.
- Position the advance speed on value "0".
- Press the button (46 Fig. F) "
able the brush rotation; the brush group
descends.
- Pressing the accelerator pedal (7 Fig. A),
the brushes hub starts to rotate gripping
the brushes, then release the pedal.
- Press the button (46 Fig. F) again "
and turn the key (29 Fig. F) to the position
"OFF".
ENGLISH - 15
" to en-
"