Safety Instructions; Trouble Shooting - Albrecht Tectalk Worker 2 Manuel

9. Safety instructions

• Service should only be done by qualified technicians.
• Do not disassemble or modify the transceiver for any reason.
• Do not expose the transceiver under direct sunlight for long time or to extremely hot condition.
• Do not place the transceiver on any unstable surface.
• Keep the transceiver out of dust, moisture, and water.
• Do not operate the transceiver or charge the battery pack under explosive conditions.

10. Trouble shooting

No Power or the radio switches off after short
time
I cannot communicate with other group
members.
You can hear the voice from other users, but
they cannot hear you
Others hear my voice with interruptions only
I hear too many stations from outside my
group
1. Check charger and correct battery
installation.
2. Clean battery contacts
3. Replace battery by fully charged or a new
battery.
4. Battery capacity poor: battery defective or at
end of lifetime, replace battery.
1. Verify, that the channel frequency and the
CTCSS are the same in the whole group. If
you use factory default programming, this is
automatically ok if all members of your group
use the same channel number between 1 and
16.
2. The other group members are not within the
transmission distance.
Your radio is tuned to a channel number
between 1 and 8 (open PMR 446 service
without codes) and your partners are using a
channel between 9 and 16.
Please change your setting to exactly the
same number as the partners are using.
1. Too weak signal - too far away
2. External mic defective? Please check with a
service technician
1. Another Group is using the same channel
number – change channel
2. You are using a channel between CH 1 and
CH 8. Please select a number between CH 9
and CH 16 for your group.
19