Troubleshooting; Specifications; Audio Inputs; Audio Outputs - Tascam MZ-223 Mode D'emploi

Troubleshooting

If you are having trouble with the operation of this
unit, please try the following before seeking repair.
If these measures do not solve the problem, please
contact the store where you purchased this unit or
TASCAM customer support service.
The unit will not turn on.
0 Confirm that the AC adapter (TASCAM PS-M1524)
is securely connected to both the outlet and the
DC jack.
Sound is not output from speakers connect-
ed via the MAIN OUTPUTS 1–3 jacks.
0 Check the settings and volume of the connected
amplifier.
0 Confirm that channel faders (
0 Confirm that the input sound source is connected
properly.
The volume is low even when faders are
raised.
0 Confirm that the GAIN (
are set properly.
The sound is distorted.
0 Confirm that the channel 1–5 GAIN knobs (
set properly.
0 Confirm that the EQ is not set too high.
0 Confirm that the channel 1–5 faders (
PUT VOL knobs (
q
Sound from a record player is strange.
0 Confirm that it is connected to channel 1–2 LINE
A jacks and that the LINE/PHONO input switch (
is set to PHONO.
0 Confirm that the grounding wire from the record
player is connected to the | (GND) connector
( ).
k
A connected device is making a humming
noise.
0 Connect a grounding wire from the metal frame of
the connected device to the | (GND) connector
( ) on this unit.
k
No sound is output from headphones.
0 Use the MONITOR SELECT (
the outputs.
14
TASCAM MZ-223
) are raised.
8
) knobs for channels 1–5
j
) and OUT-
8
) are not set too high.
) switches to select
r
No sound is output from the monitoring sys-
tem connected to the MONITOR OUT jacks.
0 Check the settings of the connected monitoring
system.
0 Confirm that the channel 1–5 GAIN knobs (
channel faders (

Specifications

Audio inputs

MIC 1–2 INPUT (BALANCED) jacks
Connectors:
XLR-3-31 (1: GND, 2: HOT, 3: COLD)
6.3mm (1/4") standard TRS jacks (Tip: HOT,
Ring: COLD, Sleeve: GND)
Input impedance: 33 kΩ
Nominal input level: -65 dBu
Nominal input level: -30 dBu
INPUTS: LINE (UNBALANCED) jacks
Connectors: RCA pin jacks
Nominal input level: -10 dBV
Maximum input level: 10 dBV
Input impedance: 22 kΩ
) are
j
0 0 dBu=0.775 Vrms, 0 dBV=1 V

Audio outputs

MAIN OUTPUTS (UNBALANCED) jacks
Connectors: RCA pin jacks
Rated output level: -10 dBV
Maximum output level: 6 dBV
)
l
Output impedance: 200 Ω
MAIN OUTPUTS (BALANCED) jacks
Connectors: XLR-3-32 (1: GND, 2: HOT, 3: COLD)
Rated output level: 4 dBu
Maximum output level: 24 dBu
Output impedance: 200 Ω
MONITOR OUT jacks
Connectors: RCA pin jacks
Rated output level: -16 dBV
Maximum output level: 0 dBV
Output impedance: 200 Ω
PHONES jack
Connectors: 6.3mm (1/4") standard stereo jack
Maximum output: 50 mW + 50 mW
0 0 dBu=0.775 Vrms, 0 dBV=1 V
) are raised.
8
(VOLUME knob at MAX)
(VOLUME knob at MIN)
(into 32 Ω load)
) and
j