WALTERSCHEID SW41 Mode D'emploi page 98

DISMANTLING / MOUNTING YOKES / CROSSES OF A
WIDE ANGLE JOINT
6. Release the first circlip of the double
yoke.
6.1 For this, press the bearing bush
against the mandrel for a short
time and operate the foot switch
simultaneously.
The circlip is released.
®
6.2 Remove the first circlip and the
circular blank.
7. Release and remove the second circlip
and the circular blank on the opposite
side. Repeat the action step 6 for this.
8. Drive both bearing bushes out of the
double yoke in two stages in each case.
8.1 Press a bearing bush (1) against
the mandrel (2) and operate the
foot switch simultaneously until the
cross kit no longer moves.
® The first stage for driving out the
first bearing bush is ended.
42
Fig. 31
Fig. 32
Fig. 33