WALTERSCHEID SW41 Mode D'emploi page 96

DISMANTLING / MOUNTING YOKE / CROSS
13. Releasing the mounted joint:
for this, press the pivot arm (1)
•
against the mandrel (2) for a short
time and operate the foot switch
simultaneously or
strike on the pivot arm (1) using a
•
hammer.
14. Lubricate the cross kit.
15. Mount the safety device. Observe the
operating manual of the drive shaft for
this.
16. Push the drive shaft halves back into
each other.
40
Fig. 27
Fig. 28