Timer - Pando PI 3200 Manuel D'installation Et D'utilisation

INOXPAN S.L.
•
Start up / Stop 2nd Booster
Action
nd
Start up 2 Booster
nd
Start up 2 Booster
nd
Stop the 2 Booster
Stop Power
•
Power management:
The table is divided in 3 separate sets of heating zones, each set having a maximum power.
If the selected heating levels for both zones exceed the maximum available amount of power, the
power management function is automatically reducing the power from one of these zones. The
display of this zone is first blinking; the level is then automatically reduced to the highest suitable
position.
Heating zone selected
[ P ] is displayed
It is possible to activate the booster function (or double booster) on several cooking zones at the
same time, for this it is necessary to use the zones in a discriminant way (A-B, A-C, B-C or A-B-C).

Timer

The timer is able to be used simultaneous with all heating zones and this with different time
settings (from 0 to 999 minutes) for each heating zone.
•
Setting and modification of the cooking time :
Action
Select the power level
Select theTimer
Decrease the time
Increase the time
After a few seconds, the [ min ] display stops with blinking.
The time is confirmed and the timer starts.
Control panel
Slide to the end of the "SLIDER"
Or press directly on the end of
the "SLIDER"
Re-press on the end of the "SLIDER"
Slide on the "SLIDER"
Slide on the "SLIDER"
A B
B A
The other heating zone: (example: power level 9)
[ 9 ] goes to [ 8 ] and blinks
Control panel
slide on the "SLIDER"
Press simultaneously key [ - ] and [ + ] Timer display on
from the timer until the
desired display is on
Press key [ - ] from the timer
Press key [ + ] from the timer
A B
B A
85
Display
[ P ]
[ and P ]
[ P ] to [ 0 ]
[ 9 ] to [ 0 ]
C
C
Display
[ 1 ] to [ P ]
[ 60 ] to 59, 58...
Time increase