Leak Check - GOK Caramatic ProTwo Instructions De Montage Et D'utilisation

Screw connections
If connections leak, there is a danger of explosion, fire or suffocation!
Gas may escape if the product is turned.
Do not turn the product after it has been installed and the connections have been
tightened.
Tighten connections only when they are not pressurised.
The gaskets at the inlet connections (if provided) must be replaced when re-assembling!
Make sure that the gaskets sit properly in the mounting and that the screws are tightened.
Connecting and installing hoses assemblies
• Connect hoses so that mechanical, thermal and chemical stresses are avoided:
 mechanical stress: e.g. do not pull the hose assembly over sharp edges
 thermal effect: e.g. avoid open flames, radiant heat
 chemical effect: e.g. avoid grease, oil, caustic substances
• Install hose assemblies so that they are not under tension (no bending and tensile strains
or torsion).
• Install hose assemblies so that their connections cannot loosen unintentionally.
• Connections to the pressure regulator with 90° outlet prevent the hose assembly from
being kinked.
• Observe the applicable national installation regulations for LPG systems.
Suitable high-pressure hoses must be used for connection to the gas cylinders.
Mounting material
Excessive force may damage the product.
This can cause leaky connections.
Attachments must be dimensioned and connected to the vehicle wall so that this provides
a secure hold on the one hand and enables forces to be deflected safely on the other.
Forces should not affect on the product.

LEAK CHECK

The liquefied gas unit must be checked for leaks by an expert* before the first start-up,
during checking and maintenance work, before the re-start and after important changes and
repair work. See USER QUALIFICATION!
Observe EN 1949 and, in Germany, DVGW worksheet G 607.
Observe the applicable national installation regulations for LPG systems.
* Experts are particularly those who, on the basis of their training, knowledge and experience
gained during practical activity, guarantee that they carry out the inspection properly.
part no. 02 592 99
Caramatic ProTwo
19