Flush-Mounted Installation; Leak Check - GOK MIC-Dose Notice De Montage Et De Service

Installation location and installation position
Right

Flush-mounted installation

• To plaster the MIC combined service box into the wall, make a suitably large recess in the
wall.
The depth of the recess determines the position of the piping to be connected.
• Remove the grey cover
direction).
• At the inlet connection
• Mark drilling holes on the wall through the openings for wall installation
• Fix the housing of the MIC combined service box in the recess using anchors and screws.
• Place the black surface-mounted cover
it with the two small screws ; the MIC combined service box is now protected from dirt.
• Plaster the housing of the MIC combined service box into the wall.
• Remove the black surface-mounted cover
• Place the grey cover
screws.
• At the outlet connection
• Connect the other end of the hose to the oil heater.
Surface-mounted installation
• Installation on the wall
• Mark drilling holes on the wall through the openings for wall installation
• For the next steps, refer to "Flush-mounted installation" without recess.

LEAK CHECK

Before using, check the piping with the product for leaks.
The LEAK CHECK is fulfilled only when the result of the test is "leakproof".
START-UP
Turn the operating handle of the quick-acting stop valve to "Open"
(arrow points in the flow direction, horizontal)
OPERATION
The product requires no operation while it is running.
CHECK
It is recommended that you carry out a LEAK CHECK during the annual maintenance or if the
oil installation has not been used for some time.
part no. 03 023 51 f
Wrong
and close the operating handle
install the piping with olive and coupling nut.
on to the open MIC combined service box and fix
on to the MIC combined service box and fix it with the two longer
install the nozzle of the hose with olive and coupling nut.
Choose the installation location of the MIC
combined service box so that when it is
horizontal the operating handle
the oil heater is easy to operate.
With horizontal piping, the MIC combined
service box must be installed about
10 to 20 cm above the level of the piping.
The incline of the piping stops dirt affecting
the function.
(arrow not in the flow
.
beside
.
.
3 / 4