Gemini CD-1800X Manuel D'instructions page 6

2. To fine tune a CUE POINT, pause play at the memorized CUE POINT
(the cue LED will glow and the PLAY/PAUSE LED will blink), then use
the JOG WHEEL (10) or SEARCH (9) dial to scan frame by frame (1/
d75th of a second) to where you want play to begin (the CUE LED will
blink while you scan). Press the PLAY/PAUSE (6) button to save the
new CUE POINT.
NOTE: DURING FINE TUNING THERE WILL BE A STUTTER EFFECT (TO HELP YOU FIND THE
BEAT). THE STUTTERING EFFECT WILL END WHEN YOU PRESS THE PLAY/PAUSE (6)
BUTTON TO SAVE THE CUE POINT.
ROBO START INSTRUCTIONS:
IN SINGLE-AUTO CUE MODE:
Use ROBO START (1) in AUTO CUE SINGLE mode to alternate play
between two CD-1800X CD players (one track from one side,
then one from the other). In AUTO CUE SINGLE mode play starts
immediately with no blank or "dead" space. ROBO START causes one
side of the CD player to play when the other side is paused.
1. Engage AUTO CUE SINGLE mode with the AUTO CUE SINGLE/
CONTINUOUS BUTTON (18).
2. Press the ROBO START BUTTON (21) to activate ROBO START. Play
will alternate between the two CD players. At the end of a track, the
playing side pauses and the other CD deck plays a track. At the end of
this track, the playing side pauses and the first CD deck resumes play.
IN CONTINUOUS MODE OR DURING NORMAL PLAY:
If you use ROBOSTART without AUTO CUE SINGLE mode
(in CONTINUOUS mode or during normal play), play will not
alternate automatically. Pressing pause on the playing side will
cause the other side to play.
1. During normal play, set a cue point on the other side of the CD player.
2. Press the ROBO START (21) button to activate ROBO START (the
button will blink).
3. Press PLAY/PAUSE (6) button on the playing side to begin play from
the cue point on the other side.
NOTE: PAUSING THE PLAYING SIDE IN THE MIDDLE OF A TRACK WILL CAUSE THE OTHER
SIDE TO PLAY. WHEN THAT TRACK ENDS, PLAY WILL BEGIN FROM THE MIDDLE OF THE
TRACK WHERE PLAY WAS PAUSED.
TROUBLE SHOOTING:
• If the disk will not play, check to see if the disc was loaded correctly
(label side up). Also check the disc for excessive dirt, scratches, etc.
• If the disc turns but there is no sound, check the cable connections. If
they are okay, check your amplifier or receiver.
• If the CD skips, check the CD for dirt or scratches. Do not assume that
the CD player is defective. Many CDs are recorded out of spec and will
skip on most or all CD players. Before sending the unit in for repair, try
playing a CD that you are sure plays properly.
In the U.S.A., if you have any problems with this unit, call 1-732-738-9003 for
customer service. Do not return equipment to your dealer!
SPECIFICATIONS:
GENERAL:
Type...................................................Single Mechanism Compact Disc Player
Disc Type.............................................Standard Compact discs (12cm, 8cm)
Time Display.............................Track Elapsed, Track Remain, or Total Remain
Variable Pitch........................± 4%, ± 8%, ± 16% Slider with Resume Switch
Pitch Bend................................................................................± 4% Maximum
Instant Start...................................................................Within 0.015 seconds
Track Selection.........................................................................1 to 99 Tracks
AUDIO SECTION:
Quantization.............................................1 Bit Linear/Channel, 3 Beam Laser
Oversampling Rate..............................................................................8 Times
Sampling Frequency...........................................................................44.1 kHz
Frequency Response.............................................................20 Hz to 20 kHz
Total Harmonic Distortion.....................................................Less Than 0.05%
Signal to Noise Ratio.............................................................................104 dB
Dynamic Range.......................................................................................98 dB
Channel Separation....................................................................90 dB (1 kHz)
Output Level...........................................................................1.9 Volts R.M.S.
Power Supply.............................................................AC 120/230V, 60/50 Hz
Dimensions....................8 1/2" W x 3 3/4" H x 12 1/2" D (216 x 95 x 317 mm)
Weight.......................................................................Player Unit 6.5 lbs (3 kg)
NOTE: SPECIFICATIONS AND DESIGN ARE SUBJECT TO CHANGE WITHOUT NOTICE FOR
PURPOSE OF IMPROVEMENT.
( )
6