Festo MPS 8066209 Notice D'utilisation page 22

Vision module
Electrical system
•
Disconnect from all sources of electrical power!
– Switch off the power supply before working on the circuit.
– Please note that electrical energy may be stored in individual components.
Further information on this issue is available in the data sheets and operating instructions
included with the components.
•
Use protective extra-low voltage only: max. 24 V dc.
•
Establishing and disconnecting electrical connections
– Electrical connections may only be established in the absence of voltage.
– Electrical connections may only be disconnected in the absence of voltage.
•
Maximum permissible current loads for cables and devices must not be exceeded.
– Always compare the current ratings of the device, the cable and the fuse.
– If these are not the same, use a separate upstream fuse in order to
provide appropriate overcurrent protection.
•
Use only connecting cables with safety plugs for electrical connections.
•
When laying connecting cables, make sure they are not kinked or pinched.
•
Do not lay cables over hot surfaces.
– Hot surfaces are identified with a corresponding warning symbol.
•
Make sure that connecting cables are not subjected to continuous tensile loads.
•
Devices with an earth terminal must always be grounded.
– If an earth connection (green-yellow laboratory socket) is available, it must always be
connected to protective earth. Protective earth must always be connected first (before voltage),
and must always be disconnected last (after voltage).
– Some devices have high leakage current. These devices must be additionally grounded
with a protective earth conductor.
•
The device is not equipped with an integrated fuse unless specified otherwise in the technical data.
• Always pull on the safety plugs when disconnecting connecting cables – never pull the cable.
22
© Festo Didactic 8065565