You can detect vague lines of a
second image
After a while, the video image
turns white. When you switch
the power supply voltage of the
external unit on and off, the signal
will be restored. The image still
turns white after a while.
7. TECHNICAL DATA
Power supply voltage
Material
Dimensions (without receiver)
Dimensions (with receiver)
Weight
Allowable ambient temperature
Protection degree
Maximum input current
Input current in standby
Colour
Monitor
Video signal
EN
Images from two video sources are
transmitted simultaneously.
Thermal defect at the external camera.
+24 V ± 8 %
Plastic
250 x 100 x 28 (HxWxD)
250 x 100 x 50 (HxWxD)
410 g
0 to 40 °C
IP30
I(Pmax) = 90 mA
I(a) = 0.2 mA, I(P) = 4 mA
white
TFT colour monitor (320 x 240 pixels, RGB)
8. 9 cm (3.5") screen diagonal
1 Vpp, symmetric
Remove the second video source from
the circuit.
Connect the second video source using a
video switcher with the existing bus.
The V1 lead of the video bus causes a short
circuit with the P or b lead. This results in
an unacceptably high power surge. Check
the wiring for short circuits.
10-575
38