Niko 10-575 Mode D'emploi page 38

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

10-575
Image settings (brightness, contrast)
Adjust the external audio unit limit (*)
Restore the factory settings
(*) The default external audio unit limit is set to 15 (door call 1: 0-15, door call 2: 16-63).
5.2. Programming with the service unit
To assign the internal video unit to a bell push button as a first or second device, check the manual of the power supply
(10-80X) or the service unit (10-870).
To assign the internal video unit to a bell push button as a third or fourth device, program the device parallel (as a
slave) with another internal unit.
Tip: For easy programming, it is recommended that you stick the serial numbers of all internal and external units that are
part of the installation onto the wiring diagram. The serial numbers can be found on the packaging and on the device. The
serial number of this internal video unit can be found inside the upper frame.
1. Connect the service unit to the external unit using terminals a, b and P, or using the designated connector.
2. Enter the key combination onto the service unit depending on the type of action you wish to perform.
Attention: Only one of the three functions (81, 82 of 83) can be programmed per internal video unit.
Action
Search for internal unit with receiver
Connect the internal video unit as a slave to a master (parallel switching)
Deactivate the configuration of the slave
Configure the free function key to transmit control function 8, thus
activating a relay, for instance
Configure the free function key as image key
Configure the free function key as light switch
5.3. Set the ringtone (volume)
5.3.1. Activate and deactivate the ring signal
• Ring signal ON
: slide the switch up.
• Ring signal OFF
5.3.2. Set the ringtone volume
The ringtone volume can be adjusted continuously.
35
: slide the switch down.
X
Key combination
* 51 #
* 89 # serial number (slave) # serial number
(master) #
* 89 # serial number (slave) # 0 #
* 83 # serial number (internal unit) #
* 81 # serial number (internal unit) #
* 82 # serial number (internal unit) # 0 #
X
X
EN

Publicité

Table des Matières
loading

Table des Matières