Do's and Don'ts:
DO
ensure only competent persons unpack/ assemble the machine.
DO
Keep your machine clean.
DO
Keep your brushes in good condition.
DO
replace any worn or damaged parts immediately.
DO
Daily examine the mains lead for damage, such as cracking or aging. If damage is found,
replace the lead before further use.
DO
Only replace the mains lead with the correct Numatic approved replacement part.
DO
ensure that the work area is clear of obstructions and/ or people.
DO
ensure that the working area is well illuminated.
DO
Pre - sweep the area to be cleaned.
DON'T
Use steam cleaners or pressure washers to clean the machine or use in the rain.
DON'T
attempt machine maintenance or cleaning unless the power plug has been removed from
the supply outlet.
DON'T Allow any inexperienced repairs. Contact your nearest service centre.
DON'T
Strain the mains lead or try to unplug by pulling on the mains lead.
DON'T
Leave the brush deck in the lowered position when not in use.
DON'T
expect the machine to provide trouble free, reliable operation unless maintained correctly.
DON'T
run the machine over any power cables during operation.
WArNING:
Operators shall be adequately instructed on the use of this machine.
This machine shall be disconnected from its power source (remove plug from socket outlet), during cleaning
or maintenance or in the event of an accident and when replacing parts or converting the machine to another
function.
This machine is not intended for use by persons (including children) with reduced physical sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction con-
cerning use of the machine by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the machine
This machine is not suitable for picking up hazardous dust.
Do not allow supply cord to come into contact with the rotating brushes or pads
As with all electrical equipment care and attention must be exercised at all times during its use, in
addition to ensuring that routine and preventive maintenance is carried out periodically in order to ensure its
safe operation.
Failure to carry out maintenance as necessary, including the
replacement of parts to the correct standard could render the equipment unsafe and the
manufacturer can accept no responsibility or liability in this respect.
When ordering spare parts always quote the model number / serial number specified on the rating plate.
This machine is for indoor use only.
The machine is not to be used or stored outdoors or in wet conditions.
Don't allow the machine to be used by inexperienced or unauthorised operators or without
appropriate training.
Only use brushed provided with the appliance or those specified in the instruction manual.
The use of other brushes may impair safety.
A full range of brushes and accessories are available for this product.
Only use brushes or pads which are suitable for the correct operation of the machine for the specific task being
preformed.
It is essential that this equipment is correct assembled and operated in accordance with current
safety regulations.
When using the equipment always ensure that all necessary precautions are taken to guarantee the safety of
the operator and any other persons who may be affected.
regular inspection and maintenance of this machine in accordance with the manufacturer's
recommendations is essential for its functional and safe operation.
233604 0811 (A01) Page 7 of 16