Hayward AquaRite AQR15CUL Manuel Du Propriétaire page 15

telephone jack) located outside, on the bottom of the enclosure. Refer to the diagram below for the
location of these connections.
Cutout for
Flow Switch
cell cable
Connector
Bonding lugs to
pool bonding system
Optional Hayward, Pentair and Polaris controls:
The Hayward, Pentair and Polaris controls use a 4 wire connection to communicate to the AquaRite
and can be wired up to 500' apart. Any outdoor rated 4 conductor cable can be used. Refer to
each manufacturer's instructions and the wiring diagrams below for proper wiring connection to the
AquaRite. NOTE: There must be only 1 "primary" unit. All other AquaRite units must be configured
as "secondary".
Hayward - Attach wires to proper screw terminals as shown below.
Pentair - Attach wires to opposite numbered screw terminals as shown below. Note that the colors
marked on the Pentair PCB do not match the AquaRite.
14
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS