Limitation Of The Water Temperature; Technical Data; Operating Instructions; Setting The Water Temperature - Bosch TR2500TO Notice De Montage Et D'utilisation

Technical data

CAUTION:
Caution:
If the safety temperature limitation has switched off the small water
heater, unplug the mains plug, open the warm water tap and allow
approx. 4 litres of water to flow. Then plug the mains plug back in.
The appliance is ready again for operation.
3.2.3

Limitation of the water temperature

The temperature of the water leaving the tap for the small water heater
can be mechanically set to stage "1" (approx. 38 °C) or stage "eco"
(approx. 60 °C) (see "Operation", page 8).
Conserving energy
• Set the rotary selector to "eco" to conserve energy.
• Hand over the installation and operating instructions to the user and
explain how the appliance operates.
4 Technical data
Type
Rated output
Rated capacity
CLICKFIX plus installation
technology
Mixed water quantities 40 °C
(15 °C/85 °C) / (15 °C/85 °C)
Variable temperature
adjustment up to
Stand-by power consumption
at 65 °C/24 h
Electrical connection
Heat-up time to 60 °C
(supply temperature 12 °C)
Fuse protection
Water connection
Maximum flow
Cable length
Dimensions
(Height×Width×Depth)
Weight, filled
Energy efficiency class
Load profile
Annual energy consumption
Daily energy consumption
Sound power level
Hot water heating
energy efficiency
5

Operating instructions

• Before using the appliance, please read the instructions
carefully and observe them!
• Important: The appliance may never be exposed to frost!
WARNING:
Risk of electric shock!
If a fault occurs, immediately disconnect the plug from the power
supply!
8
TR2500TO 5 T
[kW] 2.2
[l] 5.0

[l] 9.5/14
[°C] 85
[kWh/d] 0.20
[V] 230
[min] 8
[A] 10
["] 3/8
[l/min] 5
[m] 0.6
[mm] 435×270×240
[kg] 7.8
A
XXS
[kWh] 531
[kWh] 2,513
[dB] 15
[%] 34,7
Immediately shut off the cold water supply to the appliance should
it leak.
Please read and observe the detailed safety instructions at the start
of these instructions!
Operation (Fig. 5)
The small water heater heats and stores drinking water up to approx. 85 °C.
5.1

Setting the water temperature

• The required outlet temperature from 35 °C to 85 °C can be set with
the rotary selector switch.
or:
• Set the required fixed outlet temperature (A):
Frost protection
1 Approx. 38 °C (soft lock-in)
eco Conserve energy approx. 60 °C (soft lock-in)
3 Hot water approx. 85 °C
The pilot lamp lights up during heat up; a little expansion water drips
from the outlet.
The appliance with be covered more quickly with limescale at higher
temperatures.
Tip: Set the rotary selector switch to "eco" to operate the appliance
economically and to reduce the effects of limescale.
Note: If the appliance has not been used for an extended period,
e. g. during a holiday, allow the water to briefly heat up to stage "3".
5.2 Limitation of the water temperature
Limit the outlet temperature to avoid scalding with hot water:
• Set the rotary selector switch to "●".
• Open the cover of the rotary selector switch.
• Select between "1" = approx. 38 °C (B1) or
"eco" = approx. 60 °C (B2).
• Close the cover.
5.3

Switching off

Set the rotary selector switch to "●" (A). The heating is switched off.
6

Cleaning

Do not use aggressive or abrasive cleaning detergents!
Do not use a steam cleaner.
• Clean appliance externally with a mild cleaning agent.
• Clean the dirt and lime scale deposits in the aerator filter.
7

Descaling

• Descale the outlet pipe with commercially available descaling agent
or vinegar.
• Please observe the manufacturers warnings when descaling.
If the water flows significantly slower when the tap is fully opened, the
small water heater and tap should be descaled by a specialist.
8

Maintenance

The following repairs and maintenance may only be carried out by an
authorised customer service representative to avoid potential sources of
danger.
TR2500TO – 6 720 876 011 (2019/05)