Maintance And Cleaning - BH LK700WS Guide D'utilisation

ASSEMBLY INSTRUCTIONS
STEP 7: MOVING INSTRUCTION
Please make sure that the following are achieved before moving the treadmill:
A. The power of treadmill is turned off.
B. Remove the plugs from the socket.
C. Remove the communication wire connected to the treadmill.
Pull Forward
Register your product warranty online at: www.BHFitnessUSA.com
20
Questions regarding warranty and parts call: 636.634.2217
POWER REQUIREMENTS AND RECOMMENDATION
• It is recommended that the machine run on a 15-20 A, 110-120 V dedicated circuit.
• Equipment must be connected to electrical circuits with an earth/ground connection.
If not, the user risks receiving an electric shock.
• Treadmills are not compatible with GFCI (Ground Fault Circuit Interrupt) plugs.
• Each machine has a breaker that will engage at 15 Amps.
• Power cord length is 72 inches (6ft)
MAINTENANCE AND CLEANING
Care has been taken to assure that your equipment has been properly adjusted and
lubricated at the factory. It is not recommended that the user attempt service on the internal
components. Instead, seek service from an authorized service center. However, you may
clean the outer surface. Use a soft cloth, dampened with warm water. Do not use aerosol
sprays or pump bottles as they may deposit sediments upon the console surface. The use
of harsh chemicals will destroy the protective coating and cause a static build-up that may
damage the some of the components.
Lift Up
MAINTENANCE AND CLEANING
NEMA 5-15R
Silicone Oil
Install the nozzle extension
Slowly pump oil from
onto the silicone oil bottle.
the silicone lubricant
Insert the Nozzle Extension
bottle onto the treadmill
about 4 inches into the
to lube.
hole.
Register your product warranty online at: www.BHFitnessUSA.com
Questions regarding warranty and parts call: 636.634.2217
NEMA 5-20R
21