Water Comsumption And Dosage - MS Schippers 2.0 Mode D'emploi

ATTENTION!!!
 The pump has to placed as near as possible to the disinfection gate, so the system
can quickly come to pressure. Maximum 10 metres are allowed.
 The end of the indication hose has to be closed, so no moisture can enter the hose.
 The threshold has to be fixed well, eventually by woodthread bolts, otherwise it will
move when cars are passing.
 The distance from the indication hose to the disinfection gate has to be minimum 5
metres, to put the system into action in time.
 When passing the disinfection gate, one has to drive slowly. Max. 5km/h

3. Water comsumption and dosage

The disinfection gate contains 15 nozzles as standard. When a bottom disinfector is connected
18 nozzles are present.
The water consumption in the disinfection gate is:
 Standard : 55 litres/minute.
 Standaard + bottom disinfection: 65 litres/minute
The quantity of disinfectant can be adjusted by means of a dosage tap, which can be found on
the inside of the control unit.
The dosage tap is manually adjustable to a dose of up to 1% disinfectant (open approximately
half a turn). The disinfectant to be used is MS Megades. Other disinfectants are not suitable for
use in combination with the MS Disinfection Gate.
According to experiments with a disinfectant concentration of 1% and a passing of the vehicle
of 30 seconds, it appears that there is sufficient active ingredient of the disinfectant to get a
proper disinfection of the vehicle. The contact time of the disinfectant is 10 minutes.
Measuring points: tires and outside of the vehicle. There are enough samples to obtain a
reliable picture.
Measurements
Measurements of the hygiene score of a vehicle that was driven by the disinfection gate of
Schippers Europe BV
Date of measurement
Hygiene score of whole vehicle including tires
Hygiene score outer body and cabin
Hygiene score of tires
Source: DLV Team Ketenprojecten, 1997
24/11/1997
9.5 (very good)
9.5 (very good)
9.5 (very good)
27