Water Comsumption And Dosage - MS Schippers 2509970 Mode D'emploi

 The indicator hose, which is connected to the bottom of the control unit, should be placed approx
5 metres in front of the disinfection gate. When a vehicle passes the hose, this will activate the
pump which will spray for the required period.
Before putting the disinfection gate into use, the pump must be filled with water with a water hose. In this
case, the dosage tap has to be closed. Otherwise the pump cannot suck. When the barrel and the pump
are completely filled with water, the dosage tap can be opened and the disinfection gate is ready for use.
You can check if all parts are delivered by checking the parts list further in this manual.
ATTENTION!!!
 The pump has to placed as near as possible to the disinfection gate, so the system can quickly
come to pressure. Maximum 10 metres are allowed.
 The end of the indication hose has to be closed, so no moisture can enter the hose.
 The threshold has to be fixed well, eventually by woodthread bolts, otherwise it will move
when cars are passing.
 The distance from the indication hose to the disinfection gate has to be minimum 5 metres, to
put the system into action in time.
 When passing the disinfection gate, one has to drive slowly. Max. 5km/h

3. Water comsumption and dosage

The disinfection gate contains a total of 11 nozzles when a bottom disinfection is connected to it.
The water consumption in the disinfection gate is± 40 litres/minute.
The quantity of disinfectant can be adjusted by means of a dosage tap, which can be found on the
outside of the control unit.
The dosage tap is manually adjustable to a dose of up to 1% disinfectant. The disinfectant to be used is
MS Megades. Other disinfectants are not suitable for use in combination with the MS Disinfection Gate.
According to experiments with a disinfectant concentration of 1% and a passing of the vehicle of 30
seconds, it appears that there is sufficient active ingredient of the disinfectant to get a proper disinfection
of the vehicle. The contact time of the disinfectant is 10 minutes.
Measuring points: tires and outside of the vehicle. There are enough samples to obtain a reliable picture.
Measurements
Measurements of the hygiene score of a vehicle that was driven by the disinfection gate of Schippers
Europe BV
Date of measurement
Hygiene score of whole vehicle including tires
Hygiene score outer body and cabin
Hygiene score of tires
Source: DLV Team Ketenprojecten, 1997
24/11/1997
9.5 (very good)
9.5 (very good)
9.5 (very good)
19