Starting The Engine - adiva AD3 200 Mode D'emploi

STARTING THE ENGINE

To prevent damage to the starter motor, do not operate the starter for more than five seconds at a time. If the vehicle
immediately, check the fuel level and battery condition, side stand position, and allow the starter motor to cool down before
To protect the catalytic converter in your vehicle's exhaust system, avoid idling for extended periods of time
Always follow proper procedure described here when starting your engine
• Place the vehicle centre stand and fold up the side stand.
•
Insert the key into the ignition and turn clockwise to the "ON" position
•
The speedometer indicator will turn a full sweep and back to zero
•
Depress the rear brake lever and push the start button
• When the engine starts, release the start button immediately, continuous activation of the
start button will damage the starter motor and gears
•
For safety, a cut-off switch is installed in the side stand and the vehicle will not start if the
stand is in the down position
•
Depressing the rear brake lever on the handlebar is required to start the engine, the foot
pedal brake(not available in some countries) does not have this capability
Caution:
attempting to start the engine again.
Caution:
and do not use leaded petrol
23
fails to start