Cooling System - adiva AD3 200 Mode D'emploi

COOLANT
Pull to open
Coolant
reserve
tank
MIN
COOLANT
• The coolant reserve tank is located in the front centre of your vehicle
•
Park your vehicle with the centre stand on level ground
•
The front fairing cover is fastened via magnetic plates, pull lightly to open
•
Inspect the coolant level by locating the "min" and "max" lines on the tank
•
Before opening the cover, ensure the engine not running and the contents is cold
•
Top up if neccessary, DO NOT overfill above the "max" line or the coolant will overflow when
the engine is hot
•
Use only high quality ethylene glycol anti-freeze that contains corrosion protection inhibitors
specifically formulated for aluminium engines. A 50:50 ratio of anti-freeze and distilled water
is required for the cooling system
Use only low-mineral drinking water or distilled water as part of the anti-freeze solution.
Water that is high in mineral content or salt may be harmful to the aluminium engine
and seals. Using coolant with silicate inhibitors may cause premature wear of the water
pump and seals or blockage of radiator passages. Using tap water can cause engine
MAX
damage.
If you are using the vehicle in an environment where it will encounter freezing
temperatures, you should have a higher concentration of anti-freeze installed by your
ADIVA Dealer to provide additional protection against freezing of the engine.
higher concentration should not exceed 60% anti-freeze to distilled water.
During warmer climates, bring the anti-freeze ratio back the standard ratio.
concentration of less than 40:60 (40% anti-freeze) will not provide proper corrosion
protection
Removing the coolant Tank cap or any cooling system hoses when hot
can cause the coolant to spray out and seriously scald you.
Allow the engine and coolant to cool down before refilling.
22
Warning!
CAUTION
The
A