Engine Oil Inspection - adiva AD3 200 Mode D'emploi

ENGINE OIL INSPECTION

A
B
Caution: HOT SURFACE!
• Place your vehicle on the centre stand on level ground
• Oil should be checked only after the vehicle has been left standing for at least 5 to 10mins
• The engine oil dipstick is located on the right side of the engine compartment
C
• Take caution the exhaust or engine may be hot when accessing the dipstick (C)
• Carefully turn counter-clockwise to loosen and remove the dipstick
• Clean the dipstick and re-insert without turning in
•
Remove the dipstick and check the oil level
• The oil level should be between "A" and "B", if insufficient, top up with recommended oil a
little at a time until the oil level is sufficient taking care not to over fill.
• Replace the dipstick with care not to damage the rubber seal and start the engine for 3 to
5mins, turn off, allow the oil to settle
• Remove the dipstick and check the oil level, top-up if necessary
• Engine oil capacity 1.5 litres, oil change capacity 1.3 litres
• Engine oil viscosity:
• If engine oil vicosity is not available, select a suitable engine according to the chart
• Use only premium quality
life. It is not advisable to mix synthetic and non-synthetic oils as the additives may
interact and cause the mixture to de-stabilise. Consult your ADIVA dealer for advice.
• Use only oils that have a SJ rating above the API service classification
15
SAE 5W-50
4-stroke
engine oil for your engine to ensure longer service