Hexagon GeoMax ZEL400H+ Manuel De L'utilisateur page 17

Using the
ZDR300 in
remote control
mode
To change the
battery
4. Turn the capture window (7) towards the laser beam and move the
detector up or down, following the indication on the LCD. A down arrow
indicates the detector should be lowered. An arrow facing up indicates the
detector should be raised. When a horizontal line appears on the display,
the detector is at the same level as the laser beam.
5. Use the two marks on the side of the ZDR300 to draw your level.
6. You can also view the same information on the LCD on the back of the
detector.
7. Press the On/Off button to turn the detector off. Automatic switch-off will
occur after 10 minutes if not used.
8. The detector has a magnetic attachment (8) for use on ceiling grids or
partition rails. To use the detector with a rod, slide the rod bracket into the
slots (6).
9. Keep the capture window (7) clean, using a soft cloth and glass cleaner.
The ZDR300 can be used for vertical setup and adjusting.
If in detection mode, press On/Off to change to the remote control functions.
To install a new 9V (LR6) battery, open the compartment on the back of the
detector.
Follow the polarity indications inside (- is next to the side wall of the detector).
Accessories ZEL400H+ | 15