Hexagon GeoMax ZEL400H+ Manuel De L'utilisateur page 11

If led A is
blinking
If led C is
blinking
If led B is contin-
uously on
A
B
C
Press on the "UP" key on the ZEL400H+ keypad (located on the bottom of the
laser keypad). If you use a ZDR300 receiver / remote be sure not to have the
receiver on and press the "UP" symbol.
Press on the "DOWN" key on the ZEL400H+ keypad (located on the bottom of
the laser keypad). If you use a ZDR300 receiver / remote be sure not to have
the receiver on and press the "DOWN" symbol.
The ZEL400H+ is levelled correctly.
If led B is continuously on but led A or C is blinking at the same time,
the ZEL400H+ is close to level.
Level the ZEL400H+ correctly using the above mentioned description.
Basic Operation ZEL400H+ | 9