Ribimex RIBILAND Pila8 Manuel D'instructions Et D'utilisation page 20

WARNING!
Never spray insecticides with a sprayer that has been used to spray herbicides, unless the unit has been
completely cleaned and flushed using the correct neutralizer as per the herbicide manufacturer's instructions.
Failure to do so can result in the killing of plants.
4.4- Putting the sprayer on your back
With your sprayer ready for use, it is recommended to place the sprayer on a table or other higher level
surface.
Once on a table or high level surface, you may pass both arms through the shoulder straps, and then pull
firmly down on the loose ends to tighten the straps.
By using this method, you will avoid unnecessary twisting or turning, and be able to tighten the shoulder
straps more easily.
4.5- Using the sprayer on the cart (only applicable to Pila16) (see Fig.7)
- To install the sprayer on the cart:
Place the sprayer on the base (9).
Align the threaded side of the knob (20) to the holes on the back of the tank (8) and tighten the knobs.
- To remove the spray from the cart:
Unscrew the knobs (20).
Remove the sprayer from the base (9).
V. OPERATION
5.1- Intended use
This product is intended for the pulverization of chemicals on plants.
It should only be used for the dispersion of phyto products, pesticides, herbicides and liquid fertilizers,
authorized and available in the specialized shops.
Always observe the instructions of the manufacturer of the liquid product.
Do not disperse other products with this sprayer.
Any other use different from that stated in this manual can cause damage to the product and present a serious
danger to the user
Do not use the sprayer for any other use, such as spraying varnish!
REMINDER
Keep people and animals away from the work area.
Never spray towards people, animals or objects that can be damaged.
Remember that the high-speed output nozzle spray can throw objects violently which could become a source
of danger. The user is solely responsible for the dangers and damage occurring to third persons or property.
5.2- Starting and stopping the sprayer (Fig.5)
(a) Charging inlet
(b) Switch 2 positions:
0 : OFF
I : ON (pressure 3 bars)
(c) Pressure controller (knob allowing adjusting the working pressure, Pila16 only)
5.2.1- Starting the sprayer
To start the sprayer: set switch in position I