Working Advice; Maintenance And Service; Maintenance And Cleaning - Bosch PSR Select Notice Originale

OBJ_BUCH-1564-002.book Page 33 Wednesday, July 10, 2013 3:28 PM
Switching On and Off
To save energy, only switch the power tool on when using it.
Note: The power tool can only be switched on when the sliding switch 7 has
been pushed to the front position.
To start the machine, press the On/Off switch 10 and keep it pressed.
The power light 12 lights up when the On/Off switch 10 is slightly or com-
pletely pressed, and allows the work area to be illuminated when lighting
conditions are insufficient.
To switch off the machine, release the On/Off switch 10.
The drill spindle is locked when the On/Off switch 10 is not pressed.
 When the drilling spindle is locked, do not press the On/Off switch 10
for more than 15 seconds. Otherwise the power tool can be damaged.
Battery Charge-control Indication
The battery charge-control indicator 5 indicates the charge condition of the
battery when the power tool is switched on.
LED
Continuous lighting, green
Continuous lighting, red
Temperature Dependent Overload Protection
When using as intended for, the power tool cannot be subject to overload.
When the load is too high or the allowable battery temperature of 65 °C is ex-
ceeded, the electronic control switches off the power tool until the tempera-
ture is in the optimum temperature range again.

Working Advice

 Apply the power tool to the screw only when it is switched off. Rotat-
ing tool inserts can slip off.

Maintenance and Service

Maintenance and Cleaning

 Before any work on the machine (e. g., maintenance, tool change,
etc.) as well as during transport and storage, set the rotational direc-
Bosch Power Tools
English | 33
Capacity
≥ 30%
< 30%
1 609 92A 0AG | (10.7.13)