Working Advice - Bosch GSR 1000 Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-2423-002.book Page 31 Tuesday, August 11, 2015 9:55 AM
Adjusting the Speed
The speed of the switched-on power tool can be variably adjusted, depending on how
far the On/Off switch 4 is pressed.
Light pressure on the On/Off switch 4 results in a low rotational speed. Further pres-
sure on the switch results in an increase in speed.
Fully automatic spindle locking (Auto-lock)
When the On/Off switch 4 is not pressed, the drill spindle and thus the tool holder are
locked.
This enables screws to be screwed in, even when the battery is empty and allows for
the machine to be used as a screwdriver.
Run-on Brake
When the On/Off switch 4 is released, the chuck brakes to a stop, thus preventing the
run-on of the tool.
When driving in screws, wait until the screw is screwed in flush with the material and
then release the On/Off switch 4. By doing so, the head of the screw does not pene-
trate into the material.
LED
Continuous lighting 3 x green
Continuous lighting 2 x green
Continuous lighting 1 x green
Flashing light 1 x green
Temperature Dependent Overload Protection
When using as intended for, the power tool cannot be subject to overload. When the
load is too high or the allowable battery temperature is exceeded, the electronic con-
trol switches off the power tool until the temperature is in the optimum temperature
range again.

Working Advice

 Apply the power tool to the screw only when it is switched off. Rotating tool in-
serts can slip off.
After longer periods of working at low speed, allow the machine to cool down by run-
ning it for approx. 3 minutes at maximum speed with no load.
For drilling in metal, use only perfectly sharpened HSS drill bits (HSS=high-speed
steel). The appropriate quality is guaranteed by the Bosch accessories program.
Bosch Power Tools
English | 31
Capacity
≥ 2/3
≥ 1/3
< 1/3
Reserve
1 609 92A 1F9 | (11.8.15)