Disposal; 12.1 Dismounting And Transport; 12.2 Complete Disposal; Accessories - Sera ABP - 030 Notice De Mise En Service

Air driven diaphragm pump
Pompe pneumatique à membrane
Operating instructions
Notice de mise en service
12

Disposal

Switch the unit off, refer to "Decommissioning".

12.1 Dismounting and Transport

•
Remove all remaining fluid, clean, neutralise and
decontaminate the device carefully.
•
Pack the device properly and arrange everything for
transport.

12.2 Complete Disposal

•
Remove all remaining fluid out of the unit.
•
Dismount all materials and send them to a suitable
processing company.
CAUTION
The consignor is liable for any defects resulting from
leaking lubricants or residual fluids!
13

Accessories

13.1 Compressed air supply unit(s)

sera - offers an optional compressed air supply unit for the air
driven diaphragm pump.
The components of the compressed air supply
units are tune to each other to facilitate
operation of the air driven diaphragm pumps
and reduce the risk of operating failures due to
control air supply problems.
Ask the sera sales department for an informative data sheet
(Data Sheet No. 10452 and 10527).
28 www.sera-web.com
13.2 Pulsation damper with automatic
diaphragm control
sera diaphragm pulsation dampers with automatic diaphragm
control ensure relatively even flow and reduce pressure spikes
which can result in undesired oscillations in the piping system.
The diaphragm pulsation damper is installed in the bypass for
the pump compressed air supply. No preloading or manual
setting is necessary. The pulsation damper automatically
adjusts to the operating conditions.

13.3 Stroke transmitting device

The stroke counter can be integrated in the drive housing of
the air driven diaphragm pump. It generates a signal for each
stroke executed by the pump, which can be electronically
processed.
(non applicable to type
APB - 650 and APB – 850)
Along with a stroke counter the sera - air driven diaphragm
pump can also be used for charge dosing. A stroke counter
also assists in timely maintenance for the pump (e.g.
inspecting/replacing the diaphragms).
Subject to technical modifications!
MPD - 25.1 . . . MPD - 850
TA 312 Rev. 21 en 08/2018