Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CORNER DESIGN
28
Step 1
Start by positioning the flooring on the ground at the loca-
tion where you wish to install the sauna.
The front part of the panel can be recognised by the ab-
sence of an electrical connector.
Step 2
Position the front panels and door with the right and left
front panel.
Important: The front panel in-
cludes 3 catches on each side.
Ensure that each catch slots in
correctly.
lift the panel with the male notch and
insert it into the female notch of the
other panel. press down to lock.
Step 3
Install the left rear panel in the groove in the flooring. .
Making sure to hold the panel.
ASSEMBLY
Step 4
Position the right rear panel in the groove in the flooring,
ensuring that it slots perfectly into the left rear panel.
Finish the assembly of two side panels by locking buckles.
Unlocked Buckle / Locked Buckle
+
+
+
+
+
+
Step 5
Carefully position the front panels, ensuring that it fits
perfectly with the side panels. Important: Keep the door
closed while handling this component.
Finish the assembly of the panels by locking buckles.
Unlocked Buckle / Locked Buckle
+
+
+
+
+
+
Step 6
Position the lower parts of the bench, ensuring that it slots
perfectly into the flooring as well as the side panels. The
heating panels must be aligned towards the door.
Connect the electrical plugs located
behind the bench.
EN
+
+
+
+
+
+
+
+
29
Publicité
Table des Matières
