Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RECTANGULAR DESIGN
24
Step 1
Start by positioning the flooring on the ground at the loca-
tion where you wish to install the sauna.
The front part of the panel can be recognised by the ab-
sence of an electrical connector.
Step 2
Install the rear panel in the groove in the flooring.
Step 3
Position the left side panel in the groove in the flooring,
ensuring that it slots perfectly into the rear panel.
Finish the assembly of two side panels by locking buckles.
Unlocked Buckle / Locked Buckle
+
+
+
+
+
+
+
+
+
+
ASSEMBLY
Step 4
Position the lower part of the bench, ensuring that it slots
perfectly into the flooring as well as the side panels. The
heating panels must be aligned towards the door.
Connect the electrical plugs located
behind the bench.
Finally, position the upper part of the
bench, ensuring that it rests securely
on the horizontal guides fixed to the
rear and side panel.
Step 5
Position the right side panel in the groove in the flooring,
ensuring that it slots perfectly into the rear panel as well
as the bench.
Finish the assembly of two side panels by locking buckles.
Unlocked Buckle / Locked Buckle
+
+
+
+
+
+
Step 6
Carefully position the front panel, ensuring that it fits per-
fectly with the side panels.
Important: Keep the door closed while handling this com-
ponent.
Finish the assembly of three side panels by locking
buckles.
Unlocked Buckle / Locked Buckle
+
+
+
+
+
+
EN
+
+
+
+
+
+
+
+
25
Publicité
Table des Matières
