Axis Communications M10 Serie Guide D'installation page 18

Page 18
Complete the wireless installation
1. Check that the wireless settings in the camera correspond to the
settings in the access point.
2. Disconnect the network cable from the camera.
3. Refresh the web page after 20-30 seconds to confirm the wireless
connection. If the camera cannot be accessed, run AXIS IP Utility
and select it from the list.
Notes:
• To establish communication, the wireless settings must be exactly the same in
the camera as in the access point or ad-hoc device.
• Keys, passphrases and certificates that are used for security must be entered
manually. Contact your Network Administrator for the requirements for the
selected access point or ad-hoc device.
• Wireless settings must always (during installation and at all other times) be
configured or changed in the camera first, before changing the settings in the
wireless access point. This ensures that the camera is always accessible when
making changes.
• SSID (Service Set Identifier) is sometimes written as ESSID (Extended Service Set
Identifier).
The installation for AXIS M1011-W/M1031-W is now complete.
AXIS M10 Series