Axis Communications M10 Serie Guide D'installation page 9

AXIS M10 Series
Assembly with extension tubes
Tube joint
Short extension tube
Connect the cables
1. Connect the camera to the network using a shielded network cable.
AXIS M1054 supports Power over Ethernet. If connecting to a
wireless network (AXIS M1011-W/M1031-W), the wired connection
is temporary in order to configure the camera's wireless settings.
See page 15 for more
2. Connect the supplied indoor power adaptor to the camera's power
connector. Skip this step if PoE is used in the case of AXIS M1054.
3. Check that the indicator LEDs indicate the correct conditions (see
page 6). Note that some LEDs can be disabled and may be unlit.
cable clip
Long extension tube
information.
Base cover
Page 9
Base plate