Axis Communications M10 Serie Guide D'installation page 113

AXIS M10 Series Page 113
Radio Transmission Regulatory Information & EMC
This equipment generates and radiates radio frequency energy, and must be installed and
operated while maintaining a minimum body-to-camera distance of 3 feet (1 meter).
If this equipment causes harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Re-orient or relocate the receiving
antenna. Increase the separation between the equipment and receiver. Connect the equipment to
an outlet on a different circuit to the receiver. Consult your dealer or an experienced radio/TV
technician for help. Shielded (STP) network cables must be used with this unit to ensure
compliance with EMC standards.
Tested to comply with FCC Standards FOR HOME OR OFFICE USE. This product must be installed
and used in strict accordance with the instructions given in the user documentation. This Axis
product complies with the following radio frequency and safety standards:
AXIS M1011/M1011-W/M1031-W/AXIS M1054
USA - This equipment has been tested and found to comply with the limits for a Class B
computing device pursuant to Subpart B of Part 15 of FCC rules, which are designed to provide
reasonable protection against such interference when operated in a commercial environment.
Operation of this equipment in a residential area is likely to cause interference, in which case the
user at his/her own expense will be required to take whatever measures may be required to
correct the interference.
Canada - This Class B digital apparatus complies with Canadian ICES-003.
Europe -
This digital equipment fulfills the requirements for radiated emission according
to limit B of EN55022, and the requirements for immunity according to EN55024 residential and
commercial industry.
Japan - This is a class B product based on the standard of the Voluntary Control Council for
Interference from Information Technology Equipment (VCCI). If this is used near a radio or
television receiver in a domestic environment, it may cause radio interference. Install and use the
equipment according to the instruction manual.
Australia - This electronic device meets the requirements of the Radio communications
(Electromagnetic Compatibility) Standard AS/NZS CISPR22:2002
AXIS M1011-W/M1031-W (Wireless)
USA - Federal Communications Commission FCC
This device complies with Part 15 of FCC Rules. Operation of the device is subject to the
following two conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference that may cause undesired operation.
Canada - This device complies with RSS-210 of Industry Canada. Operation is subject to the
following conditions:
(1) This device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Europe - EU Declaration of Conformity. This device complies with the requirements of the R&TTE
Directive 1999/5/EC with essential test suites as per standards:
EN 301 489 General EMC requirements for radio equipment,
ETS 300 328 Technical requirements for radio equipment.
Japan - This product complies with Technical Regulations Conformity Certification of Specified
Radio equipment.
Australia - This electronic device meets the requirements of the Radio communications
(Electromagnetic Compatibility) Standard AS/NZS 4771.