Low Battery; Battery Holder / Backup Installation - Napoleon Ascent Deep Serie Manuel Du Propriétaire

remote control layout
EN
3.8

low battery

The life span of the remote batteries depends on various factors: quality of the batteries,
the number of ignitions, etc.
When the transmitter batteries are low, a battery icon will appear on the LCD display
before all battery power is lost. When the batteries are replaced, this icon will disappear.
When the receiver batteries are low, no "beep" will be emitted from the receiver when
it receives an on/off command. This in an alert for the receiver that there's low battery.
When the batteries are replaced the "beep" will be emitted from the receiver when the on/off key is pressed.
If the batteries of the receiver or transmitter are low, the appliance can be turned on manually by sliding the
three position slider switch on the receiver to the on position. This will bypass the remote control feature and the
appliance main burner will come on if the gas valve is in the on position.
3.9

battery holder / backup installation

A. The battery holder is located in the valve
compartment, accessible for programming the
remote.
B. Install 4 AA batteries, Ensure that the
positive and negative ends correspond with
those identified in the battery holder.
C. In the case of a power outage, the 3 position
slider switch needs to be in the "ON" (left) or
"REMOTE (middle) position.
10
W415-2913 / C / 09.21.20
RESET/PROGRAM BUTTON (PRG)
76
°F