8- Specific Installations; 9- Changing Furling System Into Headfoil (Lx/Rx/Rs Removable Drums) - Facnor Torlon LS Serie Notice De Montage

8- SPECIFIC INSTALLATIONS

Installation without deflector wheel or when using a sail with shorter luff:
15°
'
A
9- CHANGING FURLING SYSTEM INTO HEADFOIL
(LX/RX REMOVABLE DRUMS)
Changing your LX/RX furling system into headfoil allows lowering the tack point and therefore
gaining length in the luff. You can then use a sail with a longer luff than your cruising Genoa.
This easy operation can be sequenced in 3 steps :
D'
C'
9 1 .
9.1- Dismantling the furling line guides :
Remove the guides (fig. D') after removing the two screws (fig. C').
9.2- Removing half plates :
Remove the two screws (fig. E') that go through the half plates. Slightly loosen the two other
screws in order to release the four half plates (fig. F').
9.3- Installing the half protection rings :
Slip the two half protection rings (fig. G'), then tighten the four screws back (fig. E').
Follow the steps the other way round to come back to your original furling systems.
F a c n o r - L S / L X / R X r e e f i n g a n d f u r l i n g s y st e m s - I n s ta l l a t io n ma n u a l
If the halyard swivel is not used, fix a block on the mast
(fig. A'); so that the halyard runs off at 15° to the
forestay. Also insure that the top cap is positioned
40mm – 139mm
between 40mm and 139mm from the bottom end of the
forestay terminal.
The halyard swivel virtually eliminates halyard wrap ;
B'
however, when using a shorter sail, rig a short strop (fig.
B') between the head of your sail to allow the top of the
halyard swivel to be positioned around 50mm from the
top section cap, when your sail is fully hoisted.
Without deflector wheel:
Sail with shorter luff
E'
F'
9 2 .
(i.e. Storm Sails and Working Jibs)
G'
9
English
:
3 .
29