Install Wood Mounting Strip - Broan Best WP29M Serie Instructions D'installation

4. REMOVE THE FILTERS AND THE GREASE DRIP RAIL(S)
A. Remove tape on filters.
Remove filters from hood and set aside.
NOTE: It is recommended to start with the
central one.
B. Remove tape on grease drip rail (1).
Lift out grease drip rail and set aside.
NOTE: The 60-inch width hood has 2 grease drip
rails.
5. REMOVE THE PAN
Using a Phillips no. 2 or Robertson no. 2 screwdriver, remove the screws retaining
the pan (shaded part on illustration beside) to the hood. Remove the pan and set
aside.

6. INSTALL WOOD MOUNTING STRIP

Measure and mark a level line on wall above cooktop location for the wood
mounting strip (see illustration beside and under step 2). Remove wood mounting
strip from back of hood.
Use #10 - 2'' flat head screws to secure the mounting strip to the drywall. Make
sure to hit the wall studs.
Due to the weight of this hood, ensure that the wood strip is
attached to all of the available studs (2 studs minimum for a 30''
width hood, more as hood width increases); not into the drywall
alone.
7. INSTALL THE FLUE AND/OR THE FLAT TOP COVER
7.1 D I
UCTED NSTALLATION
For a ducted installation, refer to the instructions sheet included with the optional decorative flue.
For ducting through back of hood only, install on hood or on the Optional Decorative Flue AEWP Series.
Refer to the instructions sheet included with the optional flat top cover.
7.2 N -D I
ON UCTED NSTALLATION
Refer to the installation sheet included with the non-duct kit for details.
NOTE: The Optional Flat Top Cover ADPWP Series can be installed on the Non-Duct Kit Flue ANKWP Series. Refer to
the instructions included with the optional flat top cover.
HD0175
CAUTION
: A) O D
PTIONAL ECORATIVE
B) O
PTIONAL FLAT TOP COVER
: N -D K
ON UCT
HD0174A
1. Drywall
2. Wood mounting strip
3. Flat head screw
F AEWP S
LUE
ADPWP S
F ANKWP S
IT LUE ERIES
- 7 -
1
R
ETAINING SCREWS LOCATION
HD0176
4. Wall anchor location
5. Back of hood outline
6. Wall studs
ERIES
ERIES