Broan Best WP29M Serie Instructions D'installation page 5

1. SELECT BLOWER OPTION AND INSTALLATION TYPE
1.1 N -D I
ON UCTED NSTALLATION
For a non-ducted installation, we recommend using interior blower Best by Broan model P6 for effectiveness. (Blower sold
separately.)
The non-duct kit ANKWP Series (sold separately) must be installed. This kit fits hood from 30-inch width up to 48-inch
width. See installation instructions included with the non-duct kit ANKWP Series.
1.2 D I
UCTED NSTALLATION
For a ducted installation, either an interior or exterior blower or in-line blower may be used with this hood. The Best by Broan
WP29M Series must be installed with blower models P6, P12, ILB3, ILB6, ILB9, ILB11, EB6, EB9, EB12 or EB15 only.
Other blowers cannot be substituted. (Blowers sold separately.)
Plan where and how the ductwork will be installed.
If installing in-line blower, refer to instructions packed with in-line blower and follow steps 1 up to 8, 11, 12, 14
and up of this manual.
Install proper-sized ductwork, elbows and roof or wall cap for the type of blower you are installing. Use metal duct tape to
seal duct joints.
ROOF CAP
DECORATIVE
6" or 12"
FLUE
or SOFFIT (152 mm
or 305 mm)
HOOD
24" TO 30" (609 mm to 762 mm)
ABOVE COOKING SURFACE
HH0068A
MODEL P6 SINGLE INTERIOR BLOWER
TYPICAL DUCTWORK
EXTERIOR BLOWER
DECORATIVE FLUE
or SOFFIT
6" or 12"
(152 mm
or 305 mm)
HOOD
24" to 30" (609 mm to 762 mm)
ABOVE COOKING SURFACE
HH0070A
MODEL EB6, EB9, EB12 OR EB15
EXTERIOR BLOWER TYPICAL DUCTWORK
7" (178 mm)
ROUND DUCT
WALL CAP
7" (178 mm)
ROUND
ELBOW
10" (254 mm)
ROUND DUCT
10" (254 mm)
ROUND ELBOW
EXTERIOR
BLOWER
- 5 -
ROOF
CAP
10" (254 mm)
ROUND DUCT
DECORATIVE
FLUE or SOFFIT 6" or 12"
(152 mm
or 305 mm)
HOOD
24" to 30" (609 mm to 762 mm)
ABOVE COOKING SURFACE
HH0069A
MODEL P12 DUAL INTERIOR BLOWER
TYPICAL DUCTWORK
10" round duct
In-line blower
Hood
24" to 30"
(609 to 762 mm)
above cooking
surface
HH0071A
MODEL ILB3, ILB6, ILB9 OR ILB11
IN-LINE BLOWER TYPICAL DUCTWORK
WALL
CAP
ROUND
TRANSITION
4½" x 18½" to 10"
(114 mm x 470 mm
to 254 mm)
(see page 3)
Roof cap
Wall
cap