Energy Consumption Display; Powermanager Function; Home Connect; Setting Up Home Connect - Bosch NITP660SUC Manuel D'utilisation

en-us Home Connect™
6.16 Energy consumption display
This function indicates the total amount of energy con-
sumed between turning the cooktop on and turning it off
again.
Once cooktop is turned off, the energy consumption is dis-
played in kWh for 10 seconds, e.g. 1.08 kWh. The accu-
racy of the display depends on various factors such as the
voltage quality of the power supply.
You can activate or deactivate this function in the basic
settings menu. → Page 21
6.17 PowerManager function
You can use the PowerManager function to set the total
power of the cooktop.
The cooktop is set at the factory; the cooktop's maximum
power is shown on the rating label. You can use this func-
tion to adjust the configuration to the requirements of each
electrical installation.
In order to not exceed this set value, the cooktop automat-
ically distributes the available power as needed between
the cooking zones that are switched on.
While the PowerManager function is activated, the output
of a cooking zone may temporarily fall below the nominal
value. In order to not exceed this set value, the cooktop
automatically distributes the available power as needed
between the cooking zones that are switched on . The
appliance regulates and selects the highest power level
automatically.
For more information, go to
→ "Basic settings", Page 21
7 Home Connect™
Home Connect™
This appliance is network-capable. Connecting your appli-
Home Connect™
ance to a mobile device lets you control its functions via
the Home Connect™ app, adjust its basic settings and
monitor its operating status.
The Home Connect™ services are not available in every
country. The availability of the Home Connect™ function
depends on the availability of Home Connect™ services in
your country. You can find information on this at:
www.home-connect.com.
The Home Connect™ app guides you through the entire
registration process. Follow the instructions in the
Home Connect™ app to implement the settings.
Tips
¡ Consult the Home Connect™ documents supplied.
7.2 Overview of the Home Connect™ settings
You can adjust the settings and network settings for Home Connect™ in the basic settings for your appliance.
Setting Selection or display
⁠ – Not connected/disconnect network
– Connect automatically
– Connect manually
– Connected
⁠ – Not connected
– Connect
22
¡ Follow the instructions in the Home Connect™ app as
well.
Notes
¡ Also note the safety information in this instruction man-
ual and ensure that it is also observed when operating
the appliance using the Home Connect™ app.
¡ Cooktops are not designed to be left unattended. Al-
ways monitor the cooking process.
¡ Operating the appliance on the appliance itself always
takes priority. It is not possible to operate the appliance
using the Home Connect™ app during this time.
¡ In networked standby mode, the appliance requires a
maximum of 2 W.
7.1 Setting up Home Connect™
Requirements
¡ The appliance is connected to the power supply and is
switched on.
¡ You have a mobile device with a current version of the
iOS or Android operating system, e.g. a smartphone.
¡ The mobile device and the appliance are within range of
your home network's Wi-Fi signal.
Download the Home Connect™ app.
1.
Open the Home Connect™ app and scan the following
2.
QR code.
Follow the instructions in the Home Connect™ app.
3.
Description and additional information
Log the appliance on in the home network (Wi-Fi) or dis-
connect from the network.
Connecting to the app
The setting is only displayed if the appliance is connected
to the home network.