Accessories - Dantherm AD 120B Manuel De Service

Accessories

Introduction Further information about individual accessories can be obtained from Dantherm A/S.
List The complete list of accessories for AD 120 B with drawing, description and product
number is shown below:
Hygrostat
Back plate
Electrical wire
holder
Dew point con-
trol DH24
xxx
Accessory Illustration Description
The dehumidifier is designed for
connection to an external hy-
grostat which is used when the
maintenance of a certain RF val-
ue is required. The hygrostat
can be set from 30-100% rela-
tive humidity.
The cable from the hygrostat
must be provided with a male
connector that fits into the de-
humidifier's hygrostat connector
on the front of the cabinet.
For standard operations minor
low pressure may occur in the
room where the dehumidifier is
located, because the regenera-
tion air is led from the room via
duct. This may in some cases
not be desirable and in such
cases the back plate with two
stubs for process air, in and re-
generation air, in may be used.
Used if mounting of electrical
wires is required.
Combines an electronic hygro-
stat and dew point control in
one and the same product. DH
24 consists of a connection box
with humidity and temperature
sensor and a separate control
panel.
Product
number
351036
351038
351035
351037
33