Simu T5E-SP Hz Notice Originale page 10

7
Programming a sensor
7.1- Open the memory of the motor from the individual control
transmitter:
- Press the "PROG" key of the transmitter for about 3 seconds. The motor
will run for 0,5 second in one direction and then in the other.
7.2- Confirm the operation from the sensor you wish to add :
- Press the "PROG" key of the sensor less than 1 second. The motor will
run for 0,5 second in one direction and then in the other.
- For group controls, repeat operations 7,1 and 7,2 for each motor in the group.
- To delete a sensor from the motor's memory: Perform operation 7.1 from the individual control transmitter and operation
7.2 from the automatic control to be deleted.
Recommendations when using a sensor: If the Wind sensor on an installation is changed or deleted, it is important to
delete it from the memory of all the motors in which it was programmed.
8
« Closing force » function
i
This function allows the closing force of the awning cassette to be increased or decreased to 3 levels high-medium-low.
Contact the awning's manufacturer before using these functions to check the compatibility of your systems.
For safety reasons, this function can only be accessed via the individual control point in 3 situations:
- After the settings confirmation and before programming the first control point.
- After programming the first control and during the next 4 cycles.
- After a single power outage and during the next 4 cycles.
1-
1- Position the motor to the halfway position using the "Down" or "Up" button. Press the "Stop" button to stop the awning.
2- To activate closing force function press twice successively:
- 1 press: For half a second press simultaneously "Stop" and "Up" buttons, without the motor rotating.
st
- 2 press: For more than 3 seconds press simultaneously "Stop" and "Up" buttons, until the motor jogs.
nd
i
The motor is now in programming mode for only 10 seconds, the motor is factory set at the medium level.
3- To increase the closing force, press the "Up" button until the awning makes a slow movement, the cassette awning's
closing force has moved up a level.
- To decrease the closing force, press the "Down" button until the awning makes a slow movement, the cassette
awning's closing force has moved down a level.
4- Confirm the new setting by pressing 2 seconds the "Stop" button, until the motor jogs. The new setting is memorized.
4/6
2-
+
0,5s. 3s.
1
2
PROG ≥ 3s.
1
2
PROG ≤ 1s.
3-
>>
>>
4-
2s.