Distribution Of Fine Seeds - Gaspardo ALIANTE Serie Emploi Et Entretien

ENGLISH

4.1.7 DISTRIBUTION OF FINE SEEDS

Distribution of quantities lower than 3 kg/ha.
During the dosing test the number of gearbox revolutions is low
because the quantity of product to be distributed is small. This
can result in irregular distribution of the product. If the operator
notes this, he should follow the instructions below.
Considering that every section (A, Fig. 55) of the dosing roller
distributes 20% of the product contained in roller itself, the number
of operating sections can be reduced and the gearbox rotation
speed increased to obtain more homogeneous distribution.
First, take the dosing roller off the machine. Then, unscrew the
knob (B, Fig. 55) using the supplied wrench and remove the lock
nut (C). Extract the section(s) to be disengaged and put them
back in their positions (1-2-3-4-5, Fig. 55) turning them by 180°.
When re-assembling the sections, make sure that during
operation the dosing grooves of the active sections are staggered
from one another (D, Fig. 55). This will give continuity to
distribution.
fig. 55
62
A
4
3
2
1
USE AND MAINTENANCE
Re-position the lock nut, tighten the knob using the supplied
wrench and assemble the roller back on the machine.
Block the cleaning element in the operating position and make
sure that the springs hook the previously overturned sections (E,
Fig.55) preventing their rotation and consequently distribution.
Perform the dosing test following the instructions supplied in
paragraph 4.2 and make sure that the real number of operating
sections is coherent with the 5 section roller.
The quantity values in the table refer to a dosing roller where 5
sections are actually operating.
When the same quantity is to be distributed, increase the
opening of the gearbox of every disengaged section by 20%.
To start distribution again using some of the sections or all of
them disassemble the roller and its parts and put them back in
their original position.
C
D
5
g
B
cod. 19502240
E