Pre-Maintenance Procedures; Releasing The Mower-Deck Curtain; Lubrication; Greasing The Bearings - Toro TimeCutter ZS 4200T Manuel De L'utilisateur

Pre-Maintenance
Procedures
Releasing the Mower-Deck
Curtain
Loosen the 2 bottom bolts of the curtain to access the
top of the mower deck
Figure 33
1. Bottom bolt
Note:
Always tighten the bolts to connect the curtain
after maintenance.
(Figure 33).
2. Curtain

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease the caster
Grease Type: No. 2 lithium grease
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings
Note:
Scrape any paint off the front of the
fitting(s).
g295619
1. Front caster tire
4. Connect a grease gun to each fitting
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
6. Wipe up any excess grease.
30
wheel bearings.
(Figure 34) with a rag.
Figure 34
ARK
g032432
(Figure 34).