Product Set Up; Product Use - Nuna tres Mode D'emploi

Product Set Up

Installation Concerns
DO NOT install this child restraint on vehicle seats with Lap Belts only. (1)
This child restraint is suitable for vehicle seats with a 3-point Retractor Safety
Belt. (2) If your vehicle has ISOFIX Anchor Points, we strongly recommend
that you connect the ISO Connector™ attachment to the ISOFIX Anchor Points
together (Forward Facing Mode). (3)
DO NOT use the rearward facing systems in seating positions where an active
frontal airbag installed. (4) Death or serious injury may occur. Please reference
vehicle owner's manual for more information.
DO NOT install this child restraint on vehicle seats that face sideways or
rearward with respect to the moving direction of the vehicle.
Please refer to your vehicle owner's manual for recommended or suggested
installation positions.
This child restraint must be installed in the rear vehicle seat. (4)
DO NOT install this on movable vehicle seats during installation.

Product Use

Side Impact Shield
1
- Must open the side impact shield to protect the child more safely. (5)
2
- The side impact shield on the opposite side of the vehicle door can be
closed to allow more seating space. (6)
Recline Adjustment
1
- Press the recline adjustment handle, and adjust the child restraint to the
proper position. (7)
2
- The recline angles are shown as (8).
There are two recline angles 5-6 for rearward facing mode, they are
marked as blue color.
There are four recline angles 1-4 for forward facing mode, they are marked
as red color.
Align the top reclining indicator with the bottom numbers for the desired
recline position.
9
TRES instructions
Height Adjustment for Head Support and Shoulder Harnesses
Please adjust the head support and shoulder harnesses to proper height
according to the child's height.
When used in rearward facing mode, the shoulder harness slots must be
even with or just below the child's shoulders. (9)-1
If the shoulder harnesses are not at proper height, the child may be thrown
from the child restraint when there is an accident.
When used in forward facing mode, the shoulder belt guides must be even
with or just above the child's shoulders. (9)-2
Squeeze the head support adjustment lever (10)-1, meanwhile pull up or push
down the head support until it snaps into one of the 10 positions.
The head support positions are shown as (10)-2.
Side wings open automatically while the headrest height is adjusted from
the 6th to 10th position.
Rearward Facing Mode
(for Child under 18kg /Newborn–4 years old)
Please install the child restraint on the rear vehicle seat, and then put the
child in the child restraint.
Installation for Rearward Facing Mode
Please adjust the child restraint to the desired recline position (2 positions
for rearward facing mode). Align the top reclining indicator with one of the
bottom blue numbers.
Make sure the shoulder harness is adjusted to proper height before
installing this child restraint.
When installing and adjusting the safety belts, make sure that both the
shoulder belt and the waist belt are not twisted and will not stop the
safety belts from functioning properly.
1
- Pass the vehicle waist belt through the vehicle waist belt slots, then
engage the vehicle buckle tongue into the buckle. (11)(12)
Vehicle waist belt must pass underneath infant insert.
2
- Pass the vehicle shoulder belt through the two rear-facing vehicle belt
slots at the back of the child restraint. (13)
Open the belt lock off and insert the shoulder belt through it. (14)
Ensure the belt lock off is completely closed when not in use to prevent
injury, or damage to vehicle upholstery.
10
TRES instructions