Parts List; Product Set Up - Nuna ZAAZ Mode D'emploi

Parts List

1
Nuna key (Harness
restraint removal tool)
2 Tray
3 Harness restraint 5 pts
4 Armbar
5 Seat cushion
6
Seat (with flap and
height adjustment lock
on reverse side)
1
3
9
Check that you have all the parts for this product before
assembling it.
Refer to the illustrations provided at the beginning of this
manual to identify each part.
7 ZAAZ instructions
7
Footrest
8
Leg frame
9
Cushion Retainer
Tools Needed:
Nuna key to remove harness
restraint when desired
(included in the box)
2
4
5
6
7
8

Product Set Up

Check that you have all the parts for this product before
assembling it. The assembly should be performed only by
adults.
Assemble Seat onto Leg Frame
Once the seat is attached to the legs of the chair, it is
considered to be a permanent assembly. However, it is
possible to reverse this assembly if the seat needs to be put
into storage or shipped. We recommend this should not be a
regular occurrence.
1
- Place the leg frame on the floor facing you, as
illustrated. (1)
2
- Take the seat. Release the lock by pulling down the latch
at the rear of the seat flap. Then pull the flap forward
completely. (2)
3
- Position the seat over the leg frame to line up the slots
behind the seat flap with the white tracks on the leg
frame, as illustrated. (3)
4
- Once the seat is correctly positioned over the white
tracks, keep the flap up and firmly push the seat
downward until you hear a click.
If the flap is not completely up you will not be able to
push the seat down. Continue to push firmly on the
sitting surface until the seat reaches its lowest position.
5
- To lock the seat, lower the flap and listen for the click as
the lock clicks back into position.
The seat is now permanently mounted to the legs and can
be adjusted within the range between the highest and
lowest positions.
ZAAZ instructions 8