MAXXMEE 03000 Mode D'emploi page 17

Digital Hot Air Frying Machine
and the control panel while the device is in operation or
immediately after it has been switched off. Wait until the
device has cooled down fully before it is transported,
cleaned or stored away. Use oven gloves when handling
the hot accessories.
Do not pour any liquids (e.g. oil or water) directly into the
■
device or the drawer or place a liquid-filled vessel into the
device. It works exclusively with hot air.
The device must always be disconnected from the mains pow-
■
er when it is left unattended and before transporting or clean-
ing the device.
Do not make any modifications to the device. Also do not
■
replace the connecting cable yourself. If the device, the con-
necting cable or the accessories of the device are damaged,
they must be replaced by the manufacturer, customer service
department or a specialist workshop in order to avoid any
hazards.
The device is not designed to be operated with an external
■
timer or a separate remote control system.
Follow the instructions in the "Cleaning and Storage" chapter!
■
DANGER – Danger of Electric
Shock
■
Use and store the device only in
closed rooms.
■
Do not use and store the device in
rooms with high humidity.
■
Never touch the device and the con-
necting cable with wet hands when
the device is connected to the mains
power.
■
If the device falls into water while it is
connected to the mains power, pull
the mains plug out of the plug socket
immediately. Only after this should
you retrieve the device from the
water. Never attempt to pull it out of
the water while it is connected to the
mains power!
■
If the device has fallen into water or
other liquids, do not use it. Before
using it again, have it checked by the
manufacturer, customer service de-
partment or an authorised distributor
in order to avoid possible hazards.
WARNING – Danger of Fire
■
Do not operate the device in the
vicinity of combustible material. Do
not place any combustible materials
(e.g. cardboard, paper, plastic) on or
in the device.
■
Do not connect the device along with
other consumers (with a high wattage)
to a multiple socket in order to pre-
vent overloading and a possible short
circuit (fire).
■
Do not use any extension cables.
EN
17