Unpacking; Correct Use; Commissioning; Safe Temperature Limit - IKA RO 5/10/15 Mode D'emploi

Unpacking

•Unpacking
- Please unpack the device carefully
- In the case of any damage a detailed report
must be set immediately (post, rail or forwar-
der)

Correct use

• Use
- For mixing and / or haeting liquids
• Range of use (inside only)
- Laboratories - Schools
- Pharmacies - Universities
The device is suitable for use in all areas except:

Commissioning

RO/RT
Observe the ambient conditions (temperature, humidity, etc.)
listed under Technical Data.
The device is switched on and off via the switch (A) located on
the right-hand side of the device. On the front panel a small
arrow labelled Power above the display (B) indicates the location
of the switch.

Safe temperature limit

RT
The max. attainable heating plate temperature is restricted to
130°C by a permanently set safety temperature limit. Once this
limit has been attained, the device switches off the heating.

Setting the safe temperature limit

RT
The safety temperature is set as follows:
Switch the device on using the On/Off switch
on the right side of the device.
As soon as the display shows SAFE, press and
hold down the Temp membrane key and use

Stirring function

RO/RT
The stirring function is started and stopped by pressing the „Start/
Stop" button (C).
Pressing the +/- buttons (E or D) increases or reduces the speed.
• Delivery scope
RO
- Magnetic stirrer
RO5/10 or 15
- power supply unit
- operating instruction
- Residential areas
- Areas that are connected directly to a low-voltage supply net-
work that also supplies residential areas.
The safety of the user cannot be guaranteed if the appliance is
operated with accessories that are not supplied or recommended
by the manufacturer or if the appliance is opreated improperly
contrary to the manufacturer's specifications or if the appliance or
the printed circuit board are modified parties.
After the device is switched on a display self-test is performed.
The display cycles through the following information:
• All segments light up
• The software version and the selected mode are displayed
• The selected "Eco Mode" is displayed
(E when ECO mode is active)
• If the drive has not been started the display reads „OFF". If
the drive has been started the selected speed is displayed.
The safe temperature limit must all-

WARNING

ways be set at least 25 °C lower then
the flash point of the media to be
processed!
the +/- membrane keys (H or I) to set the
desired safety temperature.
The set safety temperature is displayed.
Once the Temp membrane key is released, the safety temperature
is saved.
RT
- Heating magnetic-
stirrer RT5/10 or 15
- mains cable
- operating instruction
11 11