Wiring; Installation Wiring Notes; Wire Size And Specifications - Mitsubishi AL-20MT-D Mode D'emploi

Les langues disponibles

Simple Application Controller

Wiring

4.1

The wiring of

Series has been designed to be safe and easy. A technician or engineer trained in the local

and national electrical standards should perform all tasks associated with the electrical wiring of the

controllers. Turn off the Power before performing any wiring operations.

•

Input and output cables should not be run through the same multicore cable or share the same wire.

•

Do not lay input/output cables near high voltage power cables.

Allow for voltage drop and noise interference with input/output lines used over an extended distance. Please

use wire that is properly sized for the current load.

4.2

Wire the Inputs and Outputs using 26 - 12 AWG wire (0.13 mm

). Strip the wire to a length of 7 +- 0.5 mm (0.250 - 0.300 inches).

Please unscrew the terminal to its widest position before inserting a wire.

Insert the wire completely into the terminal to ensure that a proper con-

nection can be made. Insert the wire into the terminal and tighten enough

to keep the wire from pulling free. To avoid damaging the wire, do not

exceed a maximum torque of 0.5 N⋅m. Please do not use tin, solder, or

any other substance on the stripped wire that might cause the wire strand

to break.

The terminals will accept a 3mm flathead screwdriver.

- 3.31

26 -12 AWG

7mm(0.276") ± 0.5mm(0.02")

Wiring 4

Series

ENG

Table des Matières