Installation Mounting Notes - Mitsubishi AL-20MT-D Mode D'emploi

α
Simple Application Controller
3.3

Installation Mounting Notes

α
The
user can install it almost anywhere but
the following points should be taken into
consideration.
Do not install in areas with: excessive or
conductive dust, corrosive or flammable
ENG
gas, moisture or rain, excessive heat,
regular impact shocks or excessive
vibration. Do not place in water or let
water leak onto the controller.
Do not allow debris to fall inside the unit
during installation.
Ke e p a s fa r a s p o s s i b l e f r o m
high-voltage cables and power equip-
ment.
α
T h e
installed in cabinets which are designed
for the assembly of devices complying
to DIN 43880 or in a control box.
Use size M4 screws when mounting by screw holes.
The connectors must be covered to prevent injury from contact with "live" wires.
* Leave a minimum of 10mm of space for ventilation between the top and bottom edges of the
troller and the enclosure walls.
Series' safe design means the
S e r i e s C o n t r o l l e r mu s t b e
6.0(0.24")
10(0.39")*
IN
L N 1 2 3 4 5 6
POWER AC INPUT
AC 100/240V
ESC
+
-
OK
RELAY OUTPUT
OUT1 OUT2 OUT3 OUT4
6.0(0.24")
71.2(2.80")
Installation 3
55.0(2.17")
α
Series Con-
12