Install The Support Plate On The Inside Of The Door; Install The Alarm Assembly; Remove The Battery Cover From The Alarm Assembly - Allegion SCHLAGE SENSE Instructions D'installation

8b Install the Support Plate on the inside of the door.
»
Make sure the Touchscreen and Support Plate are straight on the door before
tightening the screws. Tighten screws fully to prevent the lock from moving over
time.
9

Install the Alarm Assembly.

9a Remove the battery cover from the Alarm Assembly.
ELECTROSTATIC DISCHARGE
WARNING!
Touching the circuit board
may damage the lock!
Route the cable
through the slot.
Actual Size (2)
Hold the Touchscreen on
the outside of the door
while you tighten the
screws.
Make sure the indented
circle is facing the door.
DO NOT remove
the battery tray
(not shown)!
9