GBC FUSION 3100L Manuel D'utilisation page 6

English
getting ready to laminate
Easy Set Up
1 Remove the plastic exit tray from the box and place into the two holes on the back of the
laminator and extend to use. Ensure that there is sufficient space behind the laminator for the
item to be removed.
2 Take the electrical plug and place in an appropriate power source, which is near the table you
intend to use.
3 The laminator will respond with a single beep and a sequence of brief flashes across the control
panel.
Touch Control
4 To use the laminator gently tap the 'power on' button.
NOTE: Your new laminator may emit
a slight odour during the initial
operation. Its is normal and will
diminish after a few hours of
operation.
5 An orange ' ' will flash indicating that the laminator is warming up to the setting which is
indicated by a white light on the control panel.
NOTE: Following "power on" it will
automatically set to the 75mic.
6 If setting indicated by white light on the control panel is not approporaite for your pouch
thickness, select the appropriate pouch setting by tapping the micron setting which is indicated
on pouch packaging. Your new selection will be indicated by a white light on control panel.
6
register this product online at www.acco.com