Important - Ribimex Ribiland PRW254A Manuel D'instructions Et D'utilisation

Important - Before starting work
- Remove the blade protector sheath.
- Check the nylon lines proper operation.
- Repeat several times the starting and stoppage of the machine to become familiar with it.
- Make trial work on small grass area to become familiar with handling the machine.
1. Ensure that tool is properly connected to power supply. Lay the extension cord behind you.
2. Wear appropriate protective equipment.
3. Clear working area off any objects likely to pose a hazard.
4. Inform persons to stay away from working area and machine while you are working.
5. Firmly hold tool with both hands, and always maintain a balanced and secure position.
6. Place nylon line above the cutting area. Do not make sudden movements.
7. Press on switch (4) to start operation.
8. Start operating on working area with slow left-to-right movement, working through small areas at a
time. Do not make sudden movements.
9. Never cut wet or very damp grass. Keep the trimmer away from hard surfaces.
10. Once work is finished, stop product by releasing the switch (4).
Note: do not put down product until the nylon line has completely stopped moving.
11. Replace the blade protector sheath after use.
I
MPORTANT
T
O PROLONG THE LIFE OF YOUR ENGINE
AND STOP THE ENGINE BY PRESSING AND RELEASING THE SWITCH GRADUALLY
5.3- Tips - grass trimmer - Working with the Nylon spool line
TRIMMING:
This is feeding the trimmer carefully into the material you wish to cut.
Tilt the head slowly to direct debris away from you.
If cutting up to a barrier such as fence, wall or tree, approach from an angle where any debris ricocheting
off the barrier will fly away from you, Move the line head slowly until the grass is cut right up the barrier,
but do not jam (overfeed) the line into the barrier.
If trimming up to a wire mesh or chain linked fence be careful to feed only up to wire. If you go to far the
line will snap off around the wire. Trimming can be done to cut through weed stems one at a time. Place
the trimmer line head near the bottom of the weed-never high up which could cause the weed to chatter
and catch the line. Rather than cut the weed right through, just use the very end of the line to wear
through the stem slowly
SCALPING AND EDGING:
Both of these are done with the line head tilted at a steep angle. Scalping is removing top growth,
including roots, leaving the earth bare.
Edging is trimming the grass back where it has spread over a sidewalk or drive way.
During both edging and scalping, hold the unit a steep angle and in a position where the debris and any
dislodged dirt and stones, will not come back towards you even if it ricochets off any hard surface.
Although the figures show examples of how to edge and scalp, every operator must find for himself the
angles which suits his body size and cutting situation
WARNING! Do not to use a steel blade for edging or scalping
Do not trim in any area where there are strands of fencing wire.
Do not cut where you cannot see what the cutting device is cutting
–
DURING OPERATION
, NOT
DO USE BY PRESSING THE SWITCH WITH JOLTS
. S
TART
.
Page 28 / 45